Atag VA6011PTUU A03 Manuel d'utilisateur télécharger pdf (Page 12)

Operating Instructions

Setting the water softener

Using the table as a guide, adjust the water softener to that which cor-

responds to the hardness of the water in your area:

0 The dishwasher must be switched off.

Setting manually:

1. Open the dishwasher door.

2. Remove the lower rack from the

dishwasher.

3. Turn the hardness range switch to 0

or 1 (see table).

4. Replace the lower rack.

Setting electronically:

5. Press the ON/OFF button.

If the only LED indicator illuminated is one that belongs to a pro-

gramme button, this means that this dishwashing cycle has been acti-

vated. The dishwashing cycle must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds.

The LED indicators of all the programme buttons that can be selected

light up.

6. Press function buttons 2 and 3 simultaneously and keep them pressed.

The LED indicators for function buttons 1 to 3 will flash.

7. Press function button 1.

The LED indicator for function button 1 will flash. The LED indicator for

the end of the dishwashing cycle is flashing and acoustic signals can be

heard simultaneously (only when the acoustic signal has been acti-

vated):

– The number of times that the LED indicator for the end of the cycle

flashes and the number of acoustic signals correspond to the new

hardness setting.

– This sequence of flashes and acoustic signals is repeated many times,

with a 5 second pause in between.

1) The water hardness will only be indicated acoustically if the acoustic signal has

been activated.

2) (°d) German degree, measure of the hardness of water

3) [mmol/l] millimol per litre, international unit for the hardness of water

4) On this setting the length of the dishwashing cycle may be slightly longer.

*) Factory setting

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

Atag VA6011PTUU A03 Manuel d'utilisateur Page 12