Atag VA6111AFUU A01 Manuel d'utilisateur télécharger pdf (Page 18)

3. Press function button 4.

The 3IN1 indicator indicates the current setting:

4. Pressing function button 4 changes the setting.

5. If the 3IN1 indicator is indicating the desired setting, press the ON/

OFF button. The setting is now saved.

Before the start of the dishwashing cycle put 3in1 detergent in the de-

tergent dispenser.

3 As the rinse aid inflow is automatically switched off when the 3in1

function is activated, it may come about because of the different qual-

ity standards in the 3in1 detergent, that the dishes do not dry suffi-

ciently.

If this happens, proceed as follows (see section “Adding rinse aid”):

• Fill up the dispenser (if this is empty) with rinse aid.

• Set rinse aid dosage to “2” mechanically.

• Activate rinse aid inflow.

If you do not want to use 3in1 products any more

If you want to stop using 3in1 products, please do the following:

• Deactivate the 3in1 function.

• Fill up the dispensers for salt and rinse aid again.

• Switch the water softener to the highest setting and perform up to

three normal cycles without loading any dishes.

• Then set the water softener to the water hardness in your area.

If you want to use 4in1 products

When using "4 in 1" detergents that integrate also anti- glass corrosion

agent into "3 in 1" formula, please follow the same indication as given

for "3 in 1" detergents.

Indicator 3 IN1 is lit 3 in 1 function activated

Indicator 3IN1 is not lit

3 in 1 function not activated

(factory setting).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Atag VA6111AFUU A01 Manuel d'utilisateur Page 18