Atag WO3011CA Manuel d'utilisateur télécharger pdf (Page 7)

7

Burner cover/burner ring

Together with the burner ring the burner

cover forms a space where the final

mixture of gas and air takes place in

order to make the gas burn correctly.

Please note: It is consequently very

important that the burner cover/ring is

placed correctly on the burner. The

burner ring has been provided with

holes for the ignition electrode, and the

thermo sensor.

If the burner cover/ring are wrongly

placed the burner will operate

incorrectly, and the burners may be

damaged within at short space of time.

Ignition electrode (A)

The burner has been provided with an

ignition electrode. As long as the

operating knob is depressed, the

automatic ignition will ensure that a

spark is emitted between the ignition

electrode and the burner cover.

Thermo Sensor (B)

The hob unit features fully-secured gas

taps (thermo-fuse)

In case the flame goes out, the thermo

sensor automatically prevents gas

admission after a few seconds (max. 90

seconds).

Note: Gas admission is always allowed

while the operation button is pressed -

See start-up procedure

Burner Main nozzle

Burner ring Burner cover

Correct

Wrong

Burner ring Burner cap

Ignition electrode (A) T hermo Sensor (B)

14

Model: WO3011CA1E/A1

WO3011CB1E/A1

Type of gas

Adjusted for: Natural: G-20 - 20mbar

G-25 - 25mbar

Category and pressures

BE: II

2E+3+

20/25 - 28/37 mbar

Max. nominal load Q, H

S

:

Wok burner = 3,9 kW x 1

Total= 3,9 kW

Convertible to bottledgas:G30-28/37 mbar

FSD

The unit features fully-secured gas taps

(thermo-fuse).

H

S

= Gross calorific value

Q = Nominal load

Voltage= 220-240 V AC

Ignition transformer= 50 HZ - 0,6 VA

CE 048 AT- 0030

Radio-noise reduction

This unit observes the current EEC-directive

on radio noise reduction.

This gas appliance is -approved and

marked in accordance with the gas appliance

Directive (90/396/CEE), the low voltage

directive (73/23/CEE) and the EMC directive

(89/336/CEE incl. the agreed directive

changes.

Technical data

The Dropinett must be connected via

an external switch with a contact

gap of min. 3 mm (the main switch

may be used)

Cable type: 0,75 mm² HO5VV-F

N L1

230 V

1N + PE

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire